220V safety control using relay module - General Electronics - Arduino Forum

Hello. The relay module controls the 220V fluorescent lamp in Arduino. It has been confirmed that the lamp also operates whenever the relay module is switched on and off. But I want to put in a fuse holder because I want to control it while preventing overcurrent more safely, Is it okay to connect the circuit like this?? I'm currently using an Arduino unit3 compatible board. Below is the code used. void setup() { // put your setup code here, to run once: pinMode(9, OUTPUT); } void

Guide for Relay Module with Arduino

Remote light switch - relay and wall switch - Project Guidance - Arduino Forum

Relay Controller 4-Channel General Purpose SPDT + 8 Channel ADC ProXR Lite - NCD Store

5v Relay - Switching Between 240v Supplies - General Electronics - Arduino Forum

Safely using a relay - General Electronics - Arduino Forum

Powering wemos D1 Mini pro and relay 5V - Microcontrollers - Arduino Forum

Relay module problem with 220v lamp - General Electronics - Arduino Forum

Advice on 220V kiln control safety - General Electronics - Arduino Forum

How to control relays in safe way (isolated) ? - Raspberry Pi Forums

Arduino Controlled Auxiliary Relays Wiring Help - General Electronics - Arduino Forum

Relay for arduino - Motors, Mechanics, Power and CNC - Arduino Forum

Relay module effecting Arduino - General Electronics - Arduino Forum

220V Switch Controller with a triac - Hardware - Arduino Forum

8 ch relay board esp12f - General Electronics - Arduino Forum